The Snap
Established Member
- Joined
- 10 Jun 2005
- Messages
- 3,147
Yep, it's the Richwell Network Stage 2 v2. If you would like to download the route, please visit www.bveroutes-trains.co.uk/richwell.html .
The route has been updated with brand new working timetables, more accurate speed limitations and more precise timings. With the help of 'Bill EWS', I have been able to code some accurate speed restrictions, and have updated the signaling at Naughton Airport to allow for shunting and real BR shunting movements. Please do read the ReadMe, as it gives the procedure which you must undertake before passing the signal at Naughton Airport Depot.
Please use the following procedure to take the train past the signal just before the Depot. This procedure is correct for the moment, however due to BVE limitations, I am unable to code the shunt signals correctly. Thanks to Bill for the full list below:
I would like to thanks all of those involved in the update, and of course the route, especially Bill.
Enjoy,
The route has been updated with brand new working timetables, more accurate speed limitations and more precise timings. With the help of 'Bill EWS', I have been able to code some accurate speed restrictions, and have updated the signaling at Naughton Airport to allow for shunting and real BR shunting movements. Please do read the ReadMe, as it gives the procedure which you must undertake before passing the signal at Naughton Airport Depot.
Please use the following procedure to take the train past the signal just before the Depot. This procedure is correct for the moment, however due to BVE limitations, I am unable to code the shunt signals correctly. Thanks to Bill for the full list below:
List of Operations to Do Before Passing Signal at Naughton Airport
(You MUST do the following steps in the order they are shown.)
- Bring the train to a stand at the signal.
- Put the reverser into 'neutral' then press the Page Down key, to isolate the TPWS.
This will completely isolate the TPWS.
- Once the TPWS is isolated you can release the brake, place the reverser into forward and drive the train onto the depot.
- The square yellow light will light to show isolation is operative.
I would like to thanks all of those involved in the update, and of course the route, especially Bill.
Enjoy,