class 323 help

[fgw first great western]

AAAAAGH i can't move the class 323 not an inch i press 2 (raising pantograph) and i don't get the sparks nor i hear them can i please have help.





regards
fgq first great western

 

[EmergencyBrake]

The reverser must be in neutral and brakes must be applied before pressing the 2 key to raise the pantograph.

 

[nutter]

You also have to 'open up the desk' by moving the reverser forward then back into neutral

 

[Daniel]

Preparing the Class 323.

Move the reverser to Forward.
Move the reverser to Neutural.
When alarm sounds, press Insert.
Press and hold "2" to raise pantograph.
Watch volts indicator. When lit, release "2".
Put reverser into Forward.
Take brakes out of EMG to B3.
Wait for doors to close.
Repeat Driver-Guard buzzer, (press "6" twice).
Release brakes.
Accelerate.

 

[fgw first great western]

ok thanks now how can i move the HST

 

[Muppet]

same as above, just the engine will start.

 

[fgw first great western]

thanks
changing the subject a bit, is there a class 65 or 70 route:idea1: :angel11:

 

[Coxster]

thanks
changing the subject a bit, is there a class 65 or 70 route:idea1: :angel11:

Do you mean a Class 165 or Class 170 route? If so then there is no specific route designed for a Class 165/166 'Turbo' but the Network West Midlands and Clarendon routes both have diagrams for Class 170 'Turbostars'.

 

[fgw first great western]

Do you mean a Class 165 or Class 170 route? If so then there is no specific route designed for a Class 165/166 'Turbo' but the Network West Midlands and Clarendon routes both have diagrams for Class 170 'Turbostars'.

well yeah

 

[Turbostar]

The Edinburgh-Aberdeen route is a good one for 170's, also 158's as well.

Mart

 

[fgw first great western]

can someone make a GOOD ROUTE please for the class 165

 

[NORTH STAR]

Reading-Basingstoke should be out later this year.

 

[Jordy]

can someone make a GOOD ROUTE please for the class 165

The 165 is an old train, BVE2 IIRC, so its unlikely to be used on BVE4 routes. However, if you go over to the trainsimcentral forums, have a look at the changing trains thread, this may enable you to run the 165 on an existing route

Hope this helps

Jordy

 

[fgw first great western]

nope it don't workad1:

 

[fgw first great western]

The 165 is an old train, BVE2 IIRC, so its unlikely to be used on BVE4 routes. However, if you go over to the trainsimcentral forums, have a look at the changing trains thread, this may enable you to run the 165 on an existing route

Hope this helps

Jordy

it goes past my place every well hour

 

[Tom]

BVE isn't real life remember, no-one has made a class 165 for BVE4, hence it can't really be used in any BVE4 route. A BVE2 version is available from Damon's site, which SHOULD be virtual-rail.co.uk but isn't (), it's actually www.coxster.co.uk.

 

[fgw first great western]

i've downloaded the circle line for bve 2 and it works perfectly same with the victoria line (but the cab is in low res):thumbrig:

 

[fgw first great western]

honest it does:toothy3: