Norwich-Birmingham went ETH in October 1982. There was booked steam heat in East Anglia up to May 1984 and a few workings in the 1984-85 winter.I remember working the Birmingham/Norwich services hauled by class 31s at least until 1982.
Loco hauled to Kings Lynn finished in May 1990 and used vacuum braked stock right to the end. I think the stock was then cascaded onto Paddington-Oxford commuter trains.Vacuum brakes and steam heat were still going strong well into the 1980s.
Yes, Thames Line loco hauled in July 1992 was the end of vacuum braked hauled stock. However, vacuum braked multiple units went on for longer.Loco hauled to Kings Lynn finished in May 1990 and used vacuum braked stock right to the end. I think the stock was then cascaded onto Paddington-Oxford commuter trains.
Dundee to Glasgow return footex. Rangers fans, IIRC.The last steam heated service train was a Footex in Scotland in October 1987, if memory serves correctly.
Indeed - the introduction of 37/4s was going to be my nomination for steam -> electric changeover.The last steam heat was in Scotland. The West Highland, Far North, Kyle, Inverness-Aberdeen and Edinburgh-Dundee services were still mostly steam heat at start of winter 1985-86. The arrival of the class 37/4s that winter then finished steam heat off quite quickly, though there were a few workings in 1986-87.
Dundee to Glasgow return footex. Rangers fans, IIRC.
First North Western used vacuum braked class 101 DMUs on service trains until December 2003. Towards the end, I recall travelling on L840, still in NSE livery and carrying its Reading number, on a Holyhead to Crewe express. It approached Colwyn Bay at 70 mph. I wasn't sure if it was due to stop. Then the driver's hand reached out and pulled the brake handle most of the way round. The train screeched to a halt right next to the footbridge.Two questions:
When did vacuum braking cease to be used on B.R. (We can ignore heritage railways, etc.)
When did regular use of steam heating end? (Again ignore steam lines, etc.)
The last steam heated service train was a Footex in Scotland in October 1987, if memory serves correctly.
Dundee to Glasgow return footex. Rangers fans, IIRC.
I had a look at my notes I made, I'll need to do some research to find the source, but I have the last steam heat as - 47117, GLQ-ABD & rtn Footex, Oct. 1987Research suggests that the date was 21/03/87 and that the loco was 47109. There are pictures on flickr including this one:
![]()
I'm not aware of any steam heat workings after the end of the 1986/87 winter.
Thanks. Rail Gen Archive has 47117 working a Glasgow-Aberdeen footex on 02/05/87, could that be the one?I had a look at my notes I made, I'll need to do some research to find the source, but I have the last steam heat as - 47117, GLQ-ABD & rtn Footex, Oct. 1987
As a regular user of sleepers in the early 1980s, IIRC all Mark 1 sleepers were dual heated, with steam being used routinely in Scotland. This only changed when the Mark 3 sleepers replaced the Mark 1s around 1983.The last steam heat was in Scotland. The West Highland, Far North, Kyle, Inverness-Aberdeen and Edinburgh-Dundee services were still mostly steam heat at start of winter 1985-86. The arrival of the class 37/4s that winter then finished steam heat off quite quickly, though there were a few workings in 1986-87.
Norwich-Birmingham went ETH in October 1982. There was booked steam heat in East Anglia up to May 1984 and a few workings in the 1984-85 winter.
Loco hauled to Kings Lynn finished in May 1990 and used vacuum braked stock right to the end. I think the stock was then cascaded onto Paddington-Oxford commuter trains.
The Network Expresses were operated with class 50/47 locos and mostly Mk I and some Mk II (older ones I think with orange plastic panels in the vestibules), presumably they were worked with vacuum braking at some point? I am not sure exactly when these NE runs ended but some good displays of braking sparks (from Mk1s) were to be seen if you happened to be on another train simultaneously approaching Paddington.I commuted between Twyford and Paddington in 1983-85 and on one evening early in 1984 I was very surprised to see the rake of Mk1s on my train home steaming merrily away with a 47/0 on the front. It was the only time I ever had steam heat during those years.
If I remember rightly, the orange panels were a later variant of Mk2. The original ones (aka Mk2z by some) had wooden paneling in the vestibules, and were the only vacuum-braked Mk2 vehicles. Also Class 50 was air brake only. So I believe the services you describe were air-braked, at least by the time you used them.The Network Expresses were operated with class 50/47 locos and mostly Mk I and some Mk II (older ones I think with orange plastic panels in the vestibules), presumably they were worked with vacuum braking at some point? I am not sure exactly when these NE runs ended but some good displays of braking sparks (from Mk1s) were to be seen if you happened to be on another train simultaneously approaching Paddington.
According to Wikipedia they were dual-braked (air and vacuum). I distinctly remember them in the days of my mis-spent youth working vacuum-braked overnight trains between Crewe and Glasgow/Perth and occasionally through to Inverness (Perth drivers signed them back in the day). They also worked vacuum-braked day and night services between Crewe/Preston and Barrow, following the withdrawal of the MetroVick Co-Bo class 28s.Also Class 50 was air brake only.
That appears to be it. Not sure where October came from!Thanks. Rail Gen Archive has 47117 working a Glasgow-Aberdeen footex on 02/05/87, could that be the one?
It is much harder to find 1987 pictures of 47117 without being swamped by preservation pictures.
Class 50 was dual braked from new. BR’s first air-brake only locos were the two prototype HST power cars, followed by Class 87.Also Class 50 was air brake only.
Apologies, must have been thinking they were the first without vacuum when they were the last with. Class 87 and anything built later was air only.According to Wikipedia they were dual-braked (air and vacuum). I distinctly remember them in the days of my mis-spent youth working vacuum-braked overnight trains between Crewe and Glasgow/Perth and occasionally through to Inverness (Perth drivers signed them back in the day). They also worked vacuum-braked day and night services between Crewe/Preston and Barrow, following the withdrawal of the MetroVick Co-Bo class 28s.
That's correct. But NSE refurbished vacuum braked MarkII vehicles for the Kings Lynn line (possibly done at Eastleigh?) which lost the wood panelling and the comfy seats. Their most recognisable interior feature after refurbishment was the Eddie Pond murals on the otherwise dull grey bulkheads.The original ones (aka Mk2z by some) had wooden paneling in the vestibules, and were the only vacuum-braked Mk2 vehicles.
I did further commuting between Twyford and Paddington in the late 80's/early 90's and I'm sure I can remember Class 50s on rakes which included Mk1s. As I spent quite a lot of time standing in vestibules I can also remember the orange panels on earlier Mk2s which often had some fading but I also remember some with dark green panelling. Also, as an aside, I can remember at least 4 occasions when there was Class 31/4 haulage - 2 single-headed and 2 double-headed, obviously to replace non-availability of regular locos.If I remember rightly, the orange panels were a later variant of Mk2. The original ones (aka Mk2z by some) had wooden paneling in the vestibules, and were the only vacuum-braked Mk2 vehicles. Also Class 50 was air brake only. So I believe the services you describe were air-braked, at least by the time you used them.
I did further commuting between Twyford and Paddington in the late 80's/early 90's and I'm sure I can remember Class 50s on rakes which included Mk1s. As I spent quite a lot of time standing in vestibules I can also remember the orange panels on earlier Mk2s which often had some fading but I also remember some with dark green panelling. Also, as an aside, I can remember at least 4 occasions when there was Class 31/4 haulage - 2 single-headed and 2 double-headed, obviously to replace non-availability of regular locos.